hi all a little introduction to my first 1/10 foff car.Its based on a axial chassi and gearbox with wheely king axles.The axles have been upgradet in the diffs and by advice from snoopmax i changed the bearings with blue sealed ones.The gearbox is stock ecxept for steeloutdrives and an alu spurgear mount.I have used strc bent alulinks for lower suspension links,and in the rear i have kept the flimsy upper wk link becourse it supports no weight and i think little flex sideways will make it more durable.In the front i have used 3 link with pan hard bar becourse its more stiff so it better can handle the weight off the batery,steering servo,engine pointing toward front and also the regulator will be in the front.Right now there is 65 mm shocks on all corners but i also have some 80 mm for it,maybe ill will use 65mm front and 80mm rear.The body on it is a tamiya cr01 toyota with the rear cut off and a alu support have been added all the way along the body edge,the plan is when i get my hands on som more alu tubes i will solder a alu rollcages for it and the roof will also be replaced with alu then. I have done 1 little test run with it with 2s and a 3650 5000kv motor and it did almost ok,but more power is wanted so i have a 3660 4000 kv i will use with 3s lipo instead.It was done with out body and the eletronics taped on it,so very short just to see if i was going in the rigt direction.The project have been standing still here the last month but i know feel for getting it finnished so can get to testing it full throttle action.
stering servo: hitec 645 mg
regulator:orion vortex racing 2-3s 100-540a with cooler
motor:3650 5000kv kina,3660 4000kv kina,novak 6,5 hv maxx motor/reg combo if first 2 one lacks power
bateries: i have bought some zippy 2s 5000mah 20-30c,rhino 3s 4000 25-35c for this project
wheels:beadlock 2,2 junfac
tires:proline sandpaws
Have any one in here tryid combining 2 different set off padle tires for the front and rear for more front traction
And wich motor is best one to use from the 2 kina motors?They can both handle 2-3s and i use alucooler with fan on it
I really would like for this car to have a lot off power so i also can race little on hills at the beach.
.jpg){kind=logo}
