Calibrate Castle Creations Mamba Max Pro 1/10 on Spektrum

[pat1337]

Hello!



Im struggling to calibrate my Castle Creations Mamba Max Pro 1/10 Scale Brushless Car Package (5700kV)


I do fine untill in the manual at Step 5 in the manual. After accepting full throttle, the red blinking led comes on.

Then I go to full brake position, but it wont register. its just blinking red for minutes.



my transmitter is an Spektrum DX3E DSM 3Ch Surface Radio.

Its binded to reciver in normal(middle/halfway) settings on all possible adjustments.

(th.trim,st.trim,st.rate and all on the top panel)


Any tips what to do?
anyone wo have had same problem?


Andreas Sommervold

[niemikko]

hi just guessing is your trims in transmitter in center position?

and when normally pressin fowerd green ligth in esc and reverse red if not chance trohtle setup to rev

sorry poor reading trims are centered.